Sakura HBK-18?23AB Manual de instrucciones descargar pdf (Pagina 10)

Reversing Servo Push Rod Connection

1 - Starlock washer.

2 - Pushrod connector.

3 - Lock screw

Fit a push rod connector as shown in diagram 5. Push the

spigot through the hole from the front and push the Starlock

washer over the spigot to lock it on. Fit the screw in the end of

the connector loosely.

Trim the plastic servo arm to length.

Ensure that the control lever on the transmitter is in the centre

and that the trimmer (small black lever below the main lever)

is also in the centre then push the short servo arm up onto the

splined servo spindle pointing in towards the boiler at 90

degrees and fix in place with its retaining screw.

The shaped cut-out in the footplate below the servo will allow

screwdriver access to the horn and push rod connector

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Sakura HBK-18?23AB Manual de instrucciones Pagina 10